Introduction:

If you own an Akrapovic exhaust, you may have noticed that it has a baffle inside it. The baffle is a cylindrical tube that separates the two sides of the exhaust and helps to distribute the flow of exhaust gases evenly. However, over time, the baffle can become clogged with debris, dirt, and other substances, which can reduce the performance of your exhaust system. In this article, we will guide you through the process of removing the baffle from your Akrapovic exhaust.

Step 1: Gather the necessary tools

Before you begin, it’s important to gather all the tools you will need for the job.

Here are the tools you will need:

• A socket wrench or adjustable wrench

• A ratchet wrench or torque wrench

• A set of Allen wrenches (usually 10mm and 15mm)

• A screwdriver or drill with a screwdriver bit

• A set of safety glasses

Step 2: Remove the exhaust system from your vehicle

The first step in removing the baffle from your Akrapovic exhaust is to remove the entire exhaust system from your vehicle. This may require disconnecting the downpipe, catalytic converter, and other components from the exhaust system. Before you begin, make sure to park your vehicle on a level surface and put on safety glasses.

Step 3: Locate the baffle inlet and outlet ports

Once you have removed the exhaust system from your vehicle, locate the inlet and outlet ports of the baffle. The inlet port is usually located at the bottom of the baffle, while the outlet port is located at the top. These ports are typically connected by a pipe that runs through the center of the baffle.

Step 4: Drill out the bolts holding the baffle in place

Using a drill with a screwdriver bit, drill out the bolts holding the baffle in place at both ends. Make sure not to overdo it and use caution when drilling to avoid damaging the exhaust system or the baffle itself.

Step 5: Remove the baffle from the exhaust pipe

Once you have drilled out the bolts, carefully remove the baffle from the exhaust pipe. Be sure not to damage the exhaust pipe or any other components of the exhaust system. If the baffle is stuck or won’t come off easily, use a socket wrench or adjustable wrench to gently apply pressure to the baffle until it comes loose.

Step 6: Clean the exhaust pipe and baffle inlet/outlet ports

Now that you have removed the baffle from your Akrapovic exhaust, it’s time to clean it up. Use a brush or compressed air to remove any debris or dirt from the exhaust pipe and the inlet and outlet ports of the baffle. If you notice any damage to the exhaust system or the baffle itself, have it repaired before using it again.

Step 7: Reinstall the baffle (optional)

If you decide to reinstall the baffle in your Akrapovic exhaust, follow the same steps as above, but in reverse order. Make sure to properly tighten all bolts and connections to ensure that the baffle is securely in place.

Summary:

Removing the baffle from your Akrapovic exhaust can greatly improve its performance and overall efficiency. By following these simple steps, you can easily remove the baffle and clean up your exhaust system. Just remember to be careful and use the right tools to avoid damaging your exhaust system or any other components.